Assembly GUIDE
or visit
wineracksamerica.com
Questions?
888.373.6057
4 Column Display Row Corner
Page 3
4. Flip rack over and secure a standard column connector to the top and bottom of your rack using the screws
provided. (figure 3)
3
FRONT OF RACK
Display corner kits are designed to show no visible hardware on the front of the rack. Use of of these following
methods to install the screwless connectors:
For no visible hardware, add wood glue to the inside of each connector notch. Place the connnector on your
rack and carefully press each notch into place. Hold until glue is dry. (figure A)
For a professional installation, secure the connectors using a finish nail gun to drive a nail through the connector
into each vertical ladder. If you do not have a finish nail gun, drive one of the provided finish nails through the
connector into each vertical ladder until it is flush. Then, countersink the nail using a nail setter until the head
of the nail is about 1/16" below the surface of the wood. (figure B)
(Optional) Purchase Crown and Base molding to cover the hardware of the top and bottom standard connectors
on the front of the rack. (figure C)
A
B
C
A
B
C
+
or
5. Attach the middle screwless connectors so that the top edge of the lower connector is 26 5/8" from the bottom
of the rack, the top edge of the middle connector is 37 1/4" from the bottom of the rack, and the top edge of the
upper connector is 51 3/4" from the bottom of the rack. Make sure the rack is flat on the floor while attaching the
screwless connectors. (figure 4)
Crown Molding
Base Molding
