ATTACHING YOUR RACK TO THE WALL
Assembly GUIDE
or visit
wineracksamerica.com
Questions?
888.373.6057
Page 2
Case/Base Aisle Rack
Depending on how many bottles you store, your wine cellar rack could weigh as much as 540 lbs.
To avoid tipping attach your racking to the wall using one of the following methods.
1. Put the rack in the desired location.
2. Shim the front of the rack so it is
parallel with the wall behind it.
3. Locate a wall stud behind the rack.
4. Drive a 2 1/2" wood screw through a
back spacer bar to attach to the stud.
1. Use "L" brackets (located at any hardware store).
2. Attach to both the rack and the wall in any out of
the way spot.
Step 1
: Place parts on a flat surface. Begin by attaching the back connectors to the ladders with a cordless drill.
BACK
FRONT
Step 2
: Flip rack over. Use brad nailer or provided finish nails to attach front and top connectors to the ladders.
Use wood glue for added support.
Step 3
: Insert middle supports into notched slots.
34 11/32"
12 25/32"
23 9/16"
Base connectors
are 2" tall
ATTACHING YOUR RACK TO THE WALL
Measurements are from
the bottom of the rack to
the top of the connector
IMPORTANT!
