Assembly GUIDE
or visit
wineracksamerica.com
Questions?
888.373.6057
Top of rack
16 5/8"
BASE RACK
UPPER RACK
Page 2
1. Find an open, flat area in which to work. Carefully remove all components from the box and remove banding
with a utility knife. Check the parts list to verify package contents.
1
BEGIN WITH BACK
OF RACK
2.
Arrange the end ladders on the floor so that the bottle support pieces face one another. Align the large gaps on each
end ladder. The end with the larger gap is the top of your rack. Attach a standard connector to the top and bottom of
your rack using the screws provided. Make sure the connectors are flush with the top and bottom of your rack. (figure 1)
Depending on the model you purchased, attach the last standard connector so that the top of the connector is
16 5/8" (base rack) or 21 1/2" (upper rack) from the bottom of the rack.
2
ATTACH FRONT
CONNECTORS
Vino Flex - Base/Upper Racks
3.
Flip the rack over and secure the screwless connectors to the top and bottom your rack using a finish nail gun to
drive a finish nail through the connector into each vertical ladder. Use wood glue for added support. (figure 2)
If you do not have a finish nail gun, drive one of the provided finish nails into each vertical ladder until it is flush.
Then, countersink the nail using a nail setter until the head of the nail is about 1/16" below the surface of the wood.
Use wood glue for added support.
4. Fill the nail holes using the wood putty provided. Simply push the putty into each hole using your thumb and wipe
excess putty off the surface using a damp cloth.
21 1/2"
