Operation -
Access Point Mode
Access Point Mode
–
Provides faster throughput speeds.
1) Connect second Ethernet cable from the LAN port on your POE to your home router.
2) Turn on the WiFi-enabled device(s) that you want to connect and scan for wireless
networks.
It may take a few minutes for the network to appear.
3) The label located on the front of Quick Start Guide or bottom of the unit has the unique
default SSID and password. Select this WiFi signal from the list of wireless networks
and connect. Once the correct SSID has been selected, enter the listed password. We
recommend you set your device(s) to automatically connect with the Winegard Extreme 2.0.
4) Once connected, open an internet browser on your device and type
10.11.12.1
into the
address bar and press ENTER (Figure 5).
This will take you to the Admin Login screen (Figure 6).
Login using:
Username:
admin
Password:
admin
.
5) INTERNET ACCESS - Select Ethernet and press SELECT (Figure 7).
Your unit is
connecting and will take about 2 minutes.
5
NOTE
: WiFi signal will stay at
No signal until connected
,
when using Access Point or Bridge Modes.
You are ready to use WiFi.
Figure 5
Figure 6
Figure 7
