Receiver Setup
Connect the receiver to a power source, and complete receiver
setup. Receiver setup for the primary receiver follows; if your receiver
differs from the options shown, you may need to consult your receiver
manual. The wording and display used in your receiver may differ
slightly.
Receiver Setup
1) With power to the Carryout G3 off, press the Menu button on your
remote. Select “
Settings
”. Figure 1.
2) Select “
Satellite
”. Figure 2.
3) In your receiver menu, you will need to identify the Satellite
menu. Once there, find the option for Satellite Setup. Figure 3.
4) Select “
3-LNB
” (18”x 20”) or “
3 Satellites
”. If given the option
of SWM or Multiswitch, select “
Multiswitch
”. Figure 4.
5) Power on the antenna, and allow the antenna 3– 4 minutes to
acquire satellites. Once the antenna has finished acquiring a
signal, the antenna will be silent. Do not proceed to the next step
until this has happened.
6) After the antenna has acquired signal, press “
Continue
”; the
receiver will automatically verify the setup.
7) Errors may be displayed on the screen. It is normal to see one or
two boxes with an
X
instead of a
. Select “
Continue
”. Figure 5.
8) Select “
Continue
” again. The program guide will download.
9) When the status bar reaches 100%, press “
Continue
”. Figure 6.
10) The receiver will run Data Feed and Guide Feed Tests for a few
moments.
11) When prompted to set up the remote, select “
Setup Remote
Later
” to do this at a later time.
12) Select “
Watch DIRECTV
”. Receiver setup is now complete.
3
Carryout G3 Portable TV Antenna
Figure 4
Figure 1
Figure 2
Figure 3
Figure 5
Figure 6
