Figure 5
Figure 7
Receiver Setup
If using two DISH receivers with the Carryout G3 antenna, both
receivers must be configured off of the primary port by following the
steps below.
If using a receiver that is currently active or has been used
previously, you will need to complete the setup by doing a Check
Switch test. To access the receiver menu for running a Check Switch
test, follow the steps below.
If you need to access the receiver menu after initial setup, follow
the steps below to reach the receiver menu.
1) Press Home button twice on your remote. On the “Home” tab,
select “
Settings
”. Figure 1.
2) Within the “Settings” menu, select “
Diagnostics
”. Figure 2.
3) Within the “Diagnostics” menu, select “
DISH
” on the left side.
Figure 3.
4) Press “
Test Installation 5
” to start the Check Switch test.
Figure 4.
5) The “Check Switch Status” screen will show the progress.
Figure 5.
6) The receiver will acquire the signal Figure 6.
7) Lastly, the receiver will download the Program Guide (figure 7).
Carryout G3 Portable TV Antenna
4
NOTE
The instructions shown are for the DISH Wally
®
Figure 1
Figure 2
Figure 3
Figure 4
Figure 6
.