FIGURE 1
INSTALLATION & ASSEMBLY
STEP 1.
Choose a location for antenna that will allow it to rest in travel
position with antenna pointing toward rear of vehicle and raise and rotate
without interfering with other roof-mounted equipment. Make sure inside
ceiling area is clear where ceiling plate will mount.
NOTE: Figure 1 shows minimum distance (10") antenna should be
located from edge of vehicle roof. We recommend you check with
your dealer or the manufacturer to see what provisions have been
made in the roof for antenna mounting. A reinforced area of roof as
well as pre-wire downlead may be available.
NOTE:
The system must be level for proper operation
. If you have a
curved roof you should use a Winegard Model RW-1000 wedge kit to
level the system.
STEP 2.
Position template on roof (last page of manual) and drill a 1-1/2"
hole through roof and ceiling of vehicle. Take care to avoid damage to
wiring which may run between roof and ceiling.
NOT TO SCALE
Vehicle Roof
RW-1000
Roof Wedge
Interior Roof
Wedge,
Optional
Antenna Controls
It is highly recomended that the antenna be
mounted on roof center line. Do not mount
antenna closer than 10" from edge of roof.
Rev. 2/2001
2
Summary of Contents for RD-4610
Page 16: ...Rev 8 97 ...
