8
STEP 15.
Check system for proper operation.
Elevate dish with crank handle. A minimum of
14 turns is needed to elevate dish. Then, move
directional handle with dish elevated. Directional
handle should turn freely. If possible, have
someone watch to make sure coax does not
bind or interfere with dish movement.
After adjusting parts for proper thickness, glue the
extension(s) and directional handle together using
ABS (plastic pipe) glue.
Look inside the directional handle and make
sure the large and small keyways line up with
the keyways in the hub.
STEP 13.
Press the directional handle onto the hub.
Point the arrow on the threaded rod. Tighten the nut
enough to snug the directional handle to the hub.
STEP 14.
Install the nut and washer on the
threaded rod. Tighten the nutenough to snug the
directional handle to the hub.
CUTTING SHAFT LENGTH, Figure 11:
Flip down handle on the elevating crank handle.
Slide elevating crank handle up shaft until snug
against directional handle. Mark the elevating shaft
at inside bottom surface of crank handle housing,
Figure 13. Cut shaft at mark, after removing crank
handle. Reinstall crank.
FIGURE 12
FIGURE 13
STEP 15.
Check system for proper operation.
Elevate dish with crank handle. A minimum of 14
turns is needed to elevate dish. Then, move
directional handle with dish elevated. Directional
handle should turn freely. If possible, have someone
watch to make sure coax does not bind or interfere
with dish movement.
Summary of Contents for RM-4600
