Winegard Shaw Direct SK-7002, Installation Manual

WARNING: Pay attention to these Pinch Points as the antenna raises! 

Using the (4) bolts and nuts provided, attach the reflector to the mounting bracket. 

Press [

POWER

] to lower the antenna to the travel position. Note: The nuts securing the dish should be tightened 

to 6-8 lb.ft.

8

FIGURE 6

FIGURE 7

Pinch Points

Pinch 

Point

Pinch Point

NOTE:  Pinch Points are called out both for your safety and to protect the cables. 

Cables will be damaged if installed incorrectly. Refer to the SKA-722 installation 

manual Pages 3-4 for proper cable attachment.

Hooking up the Shaw Direct receiver

Connect your Shaw Direct receiver to the TV using the appropriate audio and video cables. (Refer to your televi-

sion user manual for the best audio /video connections). 

If you have not chosen a programming package for your Shaw Direct system or added this receiver to your exist-

ing Shaw Direct account, please call 1-888-554-7827 prior to using your Shaw Direct receiver for the first time.

Ensure that your Shaw Direct receiver is connected to power. 

Locate the coaxial feed coming from TRAV’LER system.

Connect the satellite feed to the coaxial input labeled with the symbol of a satellite dish.

Power on the Shaw Direct receiver and television. 

If your TRAV’LER system is properly tuned and receiving signal, the satellite dish icon on the front of the Shaw 

Direct receiver will be highlighted in green. 

If the TRAV’LER system is stowed or not tuned to the Shaw Direct satellites, the satellite icon on the front of the 

Shaw Direct receiver will appear in red. Turn on the TRAV’LER unit or troubleshoot as needed to reachieve posi-

tive signal.

If your Shaw Direct system is disconnected from power for an extended period of time or you has been recently 

moved from another location, you may need to have your Shaw Direct system reauthorized. This can be deter-

mined when you receive a green (positive) signal, but cannot receive video on a subscribed channel. 

To initiate a signal refresh, call 1-888-554-7827, then select “Self-Serve”, “Technical Support”, followed by “Signal 

Refresh” from the telephone menu options. 

For changes to Shaw Direct programming or to purchase new Shaw Direct equipment visit  

shawdirect.ca or call 1-888-554-7827.

NOTE: The TRAV’LER antenna will find the satellites without the receiver installed. 

INSTALLATION

Rev. 4/09