3
Togo Roadlink
™
C2 Installation
Choosing a Location for the Antenna & Power Supply
Before mounting the antenna, determine a location for the wall plate/
power supply. Keep in mind 12 V connection must be made from
the Roadlink C2 to the back of the power supply and from the power
supply to a RV power source. It is recommended to use 18 gauge wire
no longer than 50 feet with a dedicated 12VDC circuit and a 3A in-line
fuse. Then, choose a location on the roof of the RV for the antenna that
meets the following requirements:
• Offers enough support for a secure installation
• Maintains adequate clearance from the edge of the roof and any
obstructions
– clearance distance of 24" needed from the antenna to front of the
vehicle
– clearance distance of at least 12" needed from the antenna to
nearest obstruction and to the edge of the roof.
12V DC Wiring Requirements
• Supply voltage – 9-16V
• Max operating current – 1A
• Max operating temperature – 60C
• Max power cable length – 50 ft
(18 gauge wire recommended)
• 3A Fuse
3
Parts List
Tools required for unpacking
& installation:
• Drill with 3/4” bit
• 1-1/4” hole saw (if mounting
switch in wall)
• Phillips screw driver #2 3/8”
• Sealant (consult RV
manufacturer for proper type for
your roof material)
• Crimping tool
• Power wire 18 gauge, 50’
maximum recommended
• Wire Stripper
Specs:
• Dimensions: 16” diameter, 8” tall,
3.75 lbs.
Front of Vehicle
Cable connections must
face back of vehicle
At least 12”
Mount on or parallel to
center line of coach
Back of Vehicle
At least 24”
Mounting Screw (20)
Wall Plate
Terminal Insulator (2)
Wall Plate Screw (2)
Cable Tie (2)
Cable Entry Plate
Power Switch
20’ Power Cable
Barrel Crimp Splice
Antenna
