4
Togo Roadlink
™
C2 Installation (cont)
Exterior
STEP 1 – Select a level spot on your roof for installation. Level the base
front-to-back and side-to-side.
STEP 2 – After selecting a location for the antenna, make sure that
the centerline of the antenna is on or parallel to the centerline of the
vehicle; the centerline of the antenna runs through the point between
the two feet where cable connections are located.
STEP 3 – Position the antenna with cables exiting toward the rear of
the vehicle. To ensure proper installation, verify that the distance from
the edge of the roof to any foot is at least twelve inches.
STEP 4 – Place the unit on the roof in its permanent location, and mark
around each base foot. Remove the unit.
STEP 5 – Apply sealant (not provided) in the areas marked for the
base feet. Place the base feet on top of the sealant. Screw down each
foot and put sealant around the edge of feet and over each screw.
STEP 6 – Decide the best location for the power cable to enter the
vehicle, as well as, the location of the wall plate power switch inside
your vehicle. Drill a ¾” hole in the roof, and push the power cable
making sure the cable is accessible from the area where the power
switch will be located.
STEP 7 – Place the provided cable entry plate over the hole and cable.
Screw the plate in place. Seal the plate and screw holes with sealant.
Interior
STEP 8 – Choose a location to install the ConnecT Wall Plate with
power On/Off switch. When selecting a location, remember that you
will need to run the su12VDC power cable from the Roadlink
C2 antenna to the switch along with power from your vehicle. It is
recommended to use 18 gauge wire no longer than 50 feet with a
dedicated 12VDC circuit and a 3A in-line fuse.
STEP 9 – For a wall or panel mount, drill or use a hole saw to create a
1¼” hole. Pull the power wires through the wall or panel.
STEP 10 – Be sure the switch is in the OFF position before continuing.
Step 11 – Slide the power switch into the wall plate.
STEP 12 – Connect the +12V power wire from the vehicle to a small red
terminal insulator (included). Crimp the connector.
STEP 13 – Connect this small red terminal insulator to the isolated
spade of the power switch. (See diagram on next page).
STEP 14 – Connect the red wire from the Roadlink C2 to the other small
red terminal insulator (included). Crimp the connector.
STEP 15 – Connect this small red terminal insulator to the other spade
on the switch.
STEP 16 – Slide the ground wire from the vehicle into one end of the
barrel crimp splice (included), and slide the black ground wire from
the C2 antenna into the opposite end of the splice. Crimp the splice.
STEP 17 – Slide the power switch back into the hole created in Step 9.
Mount the wall plate with the two supplied wall plate screws.
STEP 18 – Turn the switch to the ON (I) position and verify that the LED
on the outside of the dome, located under the SIM Card/LED cover
plate, has turned on.
