9. Connect the other ends of the
sheathed cables to coax ports A–C
on the top of the turret. Tighten
each cable until fingertight, and
then use a
7
/
16
” wrench to tighten
a quarter turn more.
10. Place the p-clamp on the
sheathed cables, and make
sure the hole in the p-clamp is
positioned above the cables.
The p-clamp must be installed
14
″
from the ends of the
sheathed cables. This point on
the cable may already be marked
by a zip tie, mark, or tape.
11. Align the hole in the p-clamp with the hole in the lift arm. Install the
screw through the p-clamp and lift arm, and tighten.
Model RP-SK42 DISH 1000 Hybrid Replacement
Cables
1. Remove and set aside the two
screws from the wider end of the
underside of the integrated adapter.
2. Carefully slide the LNB out from the
integrated adapter. Disconnect the
three cables from the LNB using a
7
/
16
” wrench.
3. Using a
7
/
16
” wrench, disconnect the
three cables from the coax ports on
the top of the turret.
4. Using a
5
/
16
″
wrench, remove the screw holding the p-clamp to the
lift arm, and detach the p-clamp from the lift arm. Set the screw and
p-clamp aside; you will need these later.
5. Once disconnected, remove the sheathed cables.
6. Run the replacement sheathed cables through the feed arm.
2
P-clamp installed 14”
from ends of sheathed
cables, next to zip tie on
sheathed cables
Screws removed
from integrated adapter
LNB slid out from
integrated adapter
Integrated
adapter