3
7. Using the supplied dual coax cable, connect the ends with red heat
shrink wrap to Port 1 on LNB and the black coax cables to Port 2 on
LNB. Tighten each cable until fingertight, and then use a 7/16”wrench
to tighten a quarter turn more.
8. Slide the LNB into the integrated adapter, and re-install the two screws
(removed earlier) through the integrated adapter and LNB.
9. Connect the red heat shrink wrapped coax to Port C on the TRAV’LER
turret and the black coax cable to Port A on the TRAV’LER turret.
Tighten each cable until fingertight, and then use a 7/16”wrench to
tighten a quarter turn more.
10. Place the p-clamp on the sheathed cables, and make sure the hole
in the p-clamp is positioned above the cables. The p-clamp must be
installed 14 inches from the ends of the sheathed cables. This point on
the cable may already be marked by a zip tie, mark, or tape.
11. Align the hole in the p-clamp with the hole in the lift arm. Install the
screw through the p-clamp and lift arm, and tighten.
Model RP-SK45 DIRECTV
®
Slimline Repl. Cables
1. Remove and set aside the
four nuts and bolts holding
the LNB guard to the feed
arm. Then, slide the LNB
guard down the feed arm and
toward the reflector.
2. Remove and set aside the two
screws holding the LNB to the
feed arm.
3. Carefully slide the LNB out from the feed arm. Disconnect the four
coax cables from the LNB using a
7
/
16
” wrench.
4. Using a
7
/
16
” wrench, disconnect the four cables from the coax ports
on the top of the turret.
5. Using a
5
/
16
″
wrench, remove the screw holding the p-clamp to the
lift arm, and detach the p-clamp from the lift arm. Set the screw and
p-clamp aside; you will need these later.
6. Once disconnected, remove the sheathed cables.
Screws holding
LNB to feed arm
Bolts holding
LNB guard
to feed arm
LNB guard
