WINEGARD
®
ENTERTAINMENT SELECT
VIDEO DISTRIBUTION SWITCH
MODEL VS-0604/VS-6412 6 Inputs/4 Outputs
OPERATION
After the connections have been properly made to the video distribution switch, you are ready to watch your
favorite programming.
USING BUTTONS ON THE FRONT OF THE VIDEO DISTRIBUTION SWITCH
VIEWING
STEP 1.
To view signals from an amplified TV Antenna, first press the TV antenna POWER button to the ON position.
This pr12 volt power to the TV antenna amplifier located inside the antenna housing. To view the TV antenna
signal on the main TV, simply press the TV ANT button located above the area marked “MAIN TV.” Follow the same
procedure for TV 2 and Exterior TV.
NOTE:
The picture quality from your outdoor TV antenna varies depending on the location of the off-air TV station in
relationship to your location. If picture quality is degraded, try turning TV antenna Power button on your video distribution
switch Off and On.
NOTE:
It is not necessary to press the TV antenna Power button for +12 volt power to the 10 dB amplifier inside the video
distribution switch. After the unit is connected to a +12 volt power source, the video distribution switch automatically
provides power to the internal 10 dB amplifier.
STEP 2.
To view Satellite signals on your main TV, press the SAT button above the area marked “Main TV.” Follow the
same procedure for TV 2 and Exterior TV.
STEP 3.
To view Cable TV signals on your main TV, press the Cable TV button above the area marked “Main TV.” Follow
the same procedure for TV 2 and Exterior TV.
NOTE: To view Cable TV signals, you must be connected to a Cable TV input on the outside of your vehicle.
Cable TV inputs are available at many of today’s campgrounds.
STEP 4.
To view VCR signals on your main TV, press the VCR button above the area marked “Main TV.” Follow the
same procedure for TV 2 and Exterior TV.
STEP 5.
To view Auxiliary signals,
such as games, camcorder, etc., on your main TV, press the AUX button above the
area marked “Main TV.” Follow the same procedure for TV 2 and Exterior TV.
STEP 6.
To view DVD signals on your Main TV, press the DVD button above the area marked “Main TV”. Follow the
same procedure for TV 2 and Exterior TV.
NOTE:
When viewing DVD signals at the three TV set locations using standard 75 ohm coaxial cable, it is necessary to
turn the TV set to channel 3 or 4 and depress the DVD modulator button on the front of the video distribution switch to the
appropriate channel 3 or channel 4 setting. If you are in an area with local broadcasting on channel 3, select channel 4 to
view DVD signals. You will have better picture quality and less co-channel interference. When distributing DVD signals
using standard 75 ohm coax cable, the 1K/75 ohm slide switch located on the back of the video distribution switch should
be moved to the 75 ohm position.
RECORDING
STEP 7.
To record programming from the Antenna, Satellite Antenna, Cable TV or Auxiliary, simply press the appropriate
button above the section marked VCR.
To record programming from the TV antenna to your VCR, press the TV ANT button above the VCR section on the video
distribution switch.
To record programming from the Satellite antenna to your VCR, press the SAT button above the VCR section on the
video distribution switch.
To record programming from Auxiliary device to your VCR, press the AUX button above the VCR section on the video
distribution switch.
To record programming from Cable TV to VCR, press Cable TV button above VCR section on video distribution switch.
