The operation mode “Off” will automatically activate when the operation mode “Control on” is
deactivate.
Fig 6-35
Synchro-Phasing System Status “Control On” LDU page
001
002
The setpoint map for the synchro phasing controller angle offsets can be seen and adjusted from
the LDU “SPS phase angle offsets” page.
1
The operation mode “Control On” must be active to adjust and control the phase angle offset.
2
Use the LDU wheel to get the correct values for “SPS Phase Angle Offsets” (001, see
3
Push the LDU wheel to select the field, rotate the LDU wheel to adjust the value and push
again the LDU wheel to confirm the value.
4
The relative phase angle is now controlled as given in
.
The operation mode “Control On” must be active to preselect and use the reference phase angle.
X72-B
AA00-0000-00AAA-043V-A
Operation Manual
Synchro phasing system
Winterthur Gas & Diesel Ltd.
- 286 -
Issue 003 2021-12
