5
Write the applicable data on the oil analysis form (for example operation conditions, fuel
parameters, cylinder lubricating feed rate).
6
Do an oil analysis of the samples on-board. The oil analysis must include the data that
follows:
•
Residual BN
•
Iron (Fe) content (if possible).
7
If necessary, do the applicable recommended procedures, refer to section
[section not
applicable for this engine]
or to the document “Lubricants” on the WinGD website (https://
www.wingd.com/).
8
Send the oil samples to a laboratory for an oil analysis.
8.1
Make sure that the sample bottles are tightly closed.
8.2
Put the sample bottles in an applicable package.
9
Compare the oil analysis from the laboratory with the oil analysis from on-board.
10
If the oil analyses are different, do the applicable recommended procedures related to the
oil analysis from the laboratory, refer to section
[section not applicable for this engine]
or
to the document “Lubricants” on the WinGD website (https://www.wingd.com/).
CLOSE UP
•
None
X72-B
AA00-0000-00AAA-371A-A
Operation Manual
Do an analysis of the cylinder oil
Winterthur Gas & Diesel Ltd.
- 368 -
Issue 003 2021-12
