Wingsland Miinivet, Quick Start Manual

 Install Propellers and Flight Battery

Press two buttons simultaneously for 3 seconds (Figure 3) to light up the Flight Battery indicator 
before the flight.

Push the battery into the battery compartment correctly to power on the aircraft directly. 
Make sure insert into the bottom correctly and fasten the bayonet.

2

NOTICE

Toggle the switch L1 to the middle position: 
Stabilized smooth GPS Mode. Toggle the 
switch L1 to L1-0 position: Aerial Photography Mode. 

Toggle the switch L1 to L1-1 position: Automatic Return-to-Home Mode (Aircraft would be flying higher 
to 20M before return to the home point if the flight height is below 20M. Aircraft would be Return-to-Home 
with maintaining the same flight height when the flight height is beyond 20M. The home point is the point 
located during the GPS initialization. Make sure no obstacles along the way home before activating 
Return-to-Home function.) 
Toggle the switch L2 to the middle position: Standard Ready to Fly Mode. Toggle the switch L2 to L2-1 
position: Forward Direction Lock Mode (The forward direction is a nose direction recorded after aircraft 
powering on with the complete of GPS initialization)

. 

Toggle the switch L2 to L2

-

0 position

:

POI Mode

 ( Record a Point of Interest

, 

the aircraft can be controlled to circle around the POI

, 

and the nose direction

always points to the POI

.) 

Attaching propellers in the direction with consistence of arrow direction marked on the aircraft 
 arms(Figure 2). Spin and Fasten Screw Nuts with included small wrench (Figure 1).Check that 
 the propellers are installed correctly and firmly before every flight.

3

Figure 1

Attaching Propellers according 
to the Arrow Direction

Green LED 1-5

Screw Nut 

Screw Nut 
Wrench

Press with holding for 3 seconds

Figure 3

Figure 2

Figure 4

Preparing the Remote Controller

Install Display Screen onto the Controller handle, press Display Screen Power Button for 3 

seconds to powering on Display Screen. (Figure 1)

Set switch L1 (Figure 2) and switch L2 (Figure 3) to the middle position. 

Install 6s AA  Alkaline Battery into the battery compartment on the back of the Remote Controller. 

Pay attention to positive and negative.(Figure 4 ) 

Reconfirm about every switch position. Place the antenna at the horizontal position pointing  
to the left (Figure 4). Then turn on the Remote Controller (Figure 5).The Remote Controller  
features a number of camera control functions, such as taking photos and videos, adjusting 
camera setting, as well as controlling tilt of camera (Refer to Minivet User Manual for detail).

Display Screen 

L2-0

Middle Position

L2-1

L1-0

Middle Position

L1-1

Switch On

Figure 1

Figure 3

Figure 2

Figure 5

Figure 4

Power Button  

Press two triangular buttons once to check the flight battery capacity level. Ensure the battery 
fully charged (Figure 4). 

222