Attaching Propellers according
to the Arrow Direction
Install Propellers and Power on/off Smart Battery
3
Battery level indicating with press once any button on the battery indicator board. Ensure the battery fully
charged.
Insert the Battery before the aircraft powering on, make sure insert into the bottom correctly and fasten
the bayonet.
Ensure the aircraft fly from a flat smooth ground and under an open area without any obstacles, passengers,
high-voltage lines and other possible electromagnetic interference.
Press two triangular buttons simultaneously with holding for 3 seconds (Figure 3) till battery powering
on and the Green/Red LED indicator lightening (Figure 4).
L2-0
Middle Position
L2-1
NOTICE
L1-0
Middle Position
L1-1
Switch On
Preparing Controller
Figure 1
Figure 3
Figure 2
Figure 4
2
Display Screen
Power Button
Install Display Screen onto the Controller handle, press Display Screen Power Button for 3 seconds
to powering on Display Screen. (Figure 1)
Set switch L1 (Figure 2) and switch L2 (Figure 3) to the middle position.
Install 6s AA Alkaline Battery into the battery compartment on the back of the Remote Controller.
Pay attention to positive and negative.
Reconfirm about every switch position.
Toggle the switch L1 to the middle position:
S t a b i l i z e d s m o o t h G P S M o d e . To g g l e t h e
switch L1 to L1-0 position: Manual Operation
Mode (It is not suitable for beginner, or under
non emergency condition.)
Toggle the switch L1 to L1-1 position: Automatic Return-to-Home Mode (Aircraft would be flying higher
to 20M before return to the home point if the flight height is below 20M. Aircraft would be Return-to-Home
with maintaining the same flight height when the flight height is beyond 20M. The home point is the point
located during the GPS initialization. Make sure no obstacles along the way home before activating
Return-to-Home function.)
Toggle the switch L2 to the middle position: Standard Ready to Fly Mode. Toggle the switch L2 to L2-1
position: Forward Direction Lock Mode (The forward direction is a nose direction recorded after aircraft
powering on with the complete of GPS initialization)
.
Toggle the switch L2 to L2
-
0 position
:
POI Mode
( Record a Point of Interest
,
the aircraft can be controlled to circle around the POI
,
and the nose direction
always points to the POI
. )
Spin Propellers and Screw Nuts in the direction with consistence of arrow direction marked on the aircraft
arms
(
Figure 2
).
Spin and Fasten Screw Nuts with Screw Nut Wrench
(
Figure 1
).
Red LED 1
Green LED 2-5
Screw Nut
Screw Nut Wrench
Figure 1
Press with holding for 3 seconds
Figure 3
Figure 2
Figure 4
