20
Rugged Mobile Computer E500RM8 User Guide
4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5. Insert the battery on the connector-pins side first, and then lower the battery into the
battery compartment. Continue to hold the Battery Release Slider before battery is fully
inserted.
6. Make sure the battery is completely lowered into the compartment before letting go the
Battery Release Slider. Battery will be flat against the housing once fully inserted.
7. Reinsert the battery by latching the bottom first (1) and then pushing the battery pack
down (2).
Caution
Do not insert your fingers into contact hole when inserting the battery.
Check the battery latch:
Removing the Battery Pack:
1.
Power off the PDA. Disconnect any cords connected to the device.
2.
Turn the PDA over, back facing up.
3.
Locate the Battery Lock Latch and push it to the “Unlocked” position.
4.
Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5.
Lift the battery out using the opening on side of battery compartment.
Summary of Contents for E500RM8 Series
Page 63: ...63 Appendix...