12
Chapter 3: First-time Operation
Chapter 3: First-time Operation
To get started:
1. Install storage card.
2. Install the battery.
3. Charge your tablet.
4. Adjust kickstand position.
5. Start the tablet.
3.1 Inserting Battery Pack
Caution
Charge the built-in back-up battery every two months to keep battery
health and prevent possible issues from battery over-discharge.
Attention
Chargez la batterie de secours intégrée tous les deux mois pour
préserver la santé de la batterie et éviter d'éventuels problèmes de décharge
excessive de la batterie.
Caution
Disconnect any cords connected to the tablet computer before
installation or removing battery procedure.
Attention
Débranchez tous les cordons connectés à la tablette avant l'installation
ou la procédure de retrait de la batterie.
To insert the standard battery pack:
1. Disconnect any cords connected to the tablet computer.
2. Turn the tablet computer over, back facing up.
3.
Locate the Battery Lock Latch and push it to the “
Unlocked
” position.
4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5. Insert the battery on the connector-pins side first, and then lower the battery into the
battery compartment.
6. Continue to hold the Battery Release Slider before battery is fully inserted.
7. Make sure the battery is completely lowered into the compartment before letting go the
Battery Release Slider.
8. Battery will be flat against the housing once fully inserted.
To remove the battery pack:
1. Shut down the tablet computer (or put it to sleep). Disconnect any cords connected to
the tablet.
2. Turn the tablet computer over, back facing up.
3.
Locate the Battery Lock Latch and push it to the “
Unlocked
” position.
4. Locate the Battery Release Slider that is spring-loaded. Pull back and hold.
5. Lift the battery out using the opening on side of battery compartment.
