23
Chapter 2: Getting Started
3.1 Cable Mounting Considerations
For a nice look and safe installation, make sure cables are neatly hidden behind the Panel PC.
Refer to
for the cable installation instruction.
CAUTION/ ATTENTION
Follow mounting instructions and use recommended mounting hardware to avoid
the risk of injury.
Suivez les instructions de montage et d'utilisation recommandé le matériel de
montage pour éviter le risque de blessure.
CAUTION/ ATTENTION
Observe all local installation requirements for connection cable type and protection
level.
Suivre tous les règlements locaux d’installations, de câblage et niveaux de
protection.
CAUTION/ ATTENTION
Turn off the device and disconnect other peripherals before installation.
Éteindre l’appareil et débrancher tous les périphériques avant l’installation.
ALTERNATING CURRENT / MISE À LE TERRE!
To prevent electrical shock, the Safety Ground location on the rear must be bonded
to the local earth ground through a minimum 12 AWG wire as short as possible
Pour éviter les chocs électriques, l’emplacement de la prise terre à l’arrière doit
être lié à terre locale, à travers un 12 AWG minimum et aussi court que possible.
3.2 Safety Precautions
Observe the following common safety precautions before installing the equipment:
•
Use separate, non-intersecting paths to route power and networking wires. If power wiring and
device wiring paths must be crossed make sure the wires are perpendicular at the intersection
point.
•
Keep the wires separated according to the interface. Wires that share similar electrical
characteristics must be bundled together.
•
Do not bundle input wiring with output wiring. Keep them separate.
•
When necessary, it is strongly advised that you label wiring to all devices in the system.
3.3 Mounting Guide
The device comes with different mounting options suitable for most of the industrial and
commercial applications. The main mounting approach is chassis - very user-friendly in terms of
installation. Refer to sub-sections below for more details.
IMPORTANT:
Perform mounting after you establish all the necessary connections. Refer to
for wiring requirements and instructions.
The power button is located under the enclosure. Make sure the device is turned ON
before it is mounted.
Summary of Contents for R15IB3S-65EX
Page 2: ......
