13
Chapter 3: Installation
3.3 Connecting Power
This section provides information on how to use connectors on the P-Cap Open Frame Panel PC.
Notice that connectors are located on the top rear side of the device. Be cautious while working
with these modules. Please carefully read the content of this chapter in order to avoid any
damages.
Installation instruction:
1. Connect the Panel PC to a power jack.
2. Connect the other side of the thermal block to the AC adapter.
3. Connect the AC adapter to the power cord.
4. Plug in the power cord to a working AC wall outlet. The device will boot automatically.
CAUTION
Use only the AC adapter included in your package
(Rating: Output 4.2 A). Using other AC adapters may damage the
device.
3.4 Connecting to Other Devices
This section explains how to connect external interfaces to the Panel PC.
3.4.1 Power Input Connector
DC power source input is a power jack connector. Power Input is 12V DC in.
Pin №
Signal Name
1
12V
2
GND
Voltage
Minimum Voltage 11.4V
Maximum Voltage 12.6V
Maximum Current 4.2A
