User Manual
Chapter 5
Mounting Solutions
10.1” S-Series HMI (Freescale)
44
5.2 Safety Precautions
Observe the following common safety precautions before installing any electronic device:
• Use separate, non-intersecting paths to route power and networking wires. If
power wiring and device wiring paths must be crossed make sure the wires are
perpendicular at the intersection point.
• Keep the wires separated according to the interface. Wires that share similar
electrical characteristics must be bundled together.
• Do not bundle input wiring with output wiring. Keep them separate.
When necessary, it is strongly advised that you label wiring to all devices in the
system.
5.3 Mounting Guide
S-series HMI devices come with different mounting options suitable for most of the
industrial and commercial applications. The main mounting approach is panel mount -
very user-friendly in terms of installation. Refer to sub-sections below for more details.
5.3.1 VESA Mount
VESA Mount compatible with swing arm mounting kits.
VESA Plate Dimensions
Screw Hole Diameter
75 x 75 mm
VESA M4 x 3 mm
*with customer’s bracket
