USER MANUAL
CHAPTER 6
MOUNTING
- 80 -
6.3 Mounting Guide
S-series HMI devices come with different mounting options suitable for most of the
industrial and commercial applications. The main mounting approach is chassis - very
user-friendly in terms of installation. Refer to sub-sections below for more details.
CAUTION/ ATTENTION
Follow mounting instructions and use recommended mounting hardware
to avoid the risk of injury.
Suivez les instructions de montage et d'utilisation recommandé le
matériel de montage pour éviter le risque de blessure.
6.3.1 Panel Mounting
Panel Mount mounting solutions is suitable for many applications where HMI should be
embedded in the machine. With this mounting solution flat surface leave no bezel in the
front.
Wall Cutout
Screw Hole Diameter
131.4 x 175.4 mm
M3 x 4mm
Mounting Instruction
1.
Prepare a fixture for the specific dimensions of the device.
2.
Cut a hole on a sub frame or panel according to the cutout dimensions.
3.
Install the device properly onto the cutout area of the sub frame or panel with
the sides of the front bezel.
4.
Fix the device to fixture with eight Philips M3x4 screws.
NOTE:
Make sure that the eight holes on gasket can fit in the mounting holes
on the device.
