USER MANUAL
CHAPTER 2
INSTALLATION
- 21 -
CHAPTER 2: INSTALLATION
This chapter provides information on how to connect the Panel PC to the source
of power, connector pinouts and the guideline to turn on/off the device.
2.1 Safety Precautions
Observe the following common safety precautions before installing any electronic
device:
• Use separate, non-intersecting paths to route power and networking
wires. If power wiring and device wiring paths must be crossed make sure
the wires are perpendicular at the intersection point.
• Keep the wires separated according to the interface. Wires that share
similar electrical characteristics must be bundled together.
• Do not bundle input wiring with output wiring. Keep them separate.
When necessary, it is strongly advised that you label wiring to all devices
in the system.
2.2 Cable Mounting Considerations
For a nice look and safe installation, make sure cables are neatly hidden
behind the Panel PC. Refer to
Chapter 2, section 2.1
for the cable installation
instruction.
CAUTION/ ATTENTION
Observe all local installation requirements for connection cable
type and protection level.
Suivre tous les règlements locaux d’installations, de câblage et
niveaux de protection.
CAUTION/ ATTENTION
Turn off the device and disconnect other peripherals before
installation.
Éteindre l’appareil et débrancher tous les périphériques avant
l’installation.
ALTERNATING CURRENT /
MISE À LE TERRE!
To prevent electrical shock, the Safety Ground location on the
rear must be bonded to the local earth ground through a
minimum 12 AWG wire as short as possible
Pour éviter les chocs électriques, l
’emplacement de la prise terre
à
l’arrière doit être lié à terre locale, à travers un 12 AWG
minimum et aussi court que possible.
