8-17
SECTION 8
APPLIANCES & INTERIOR FEATURES
SIGNAL AMPLIFIER
The amplifier power switch is located on the
video selector system panel in the driver’s com-
partment overhead cabinet.
To operate amplifier, turn on power switch.
Other TV jack plates are mounted in various
locations throughout the coach. Some of these
wall plates are not readily visible and may be in
one of the following locations.
·
In the flip-down entertainment tray on the
outside of the coach.
Checking Signal Performance
The TV signals available to an RV are entirely
dependent on its location in relation to the trans-
mitter. Signals may vary from strong to no usable
signal at all. We recommend that the TV system
be checked out in an area known to have good TV
reception.
To check the antenna amplifier, raise the an-
tenna, select a TV channel and rotate the antenna
for best picture. Then turn off the amplifier pow-
er switch. If the antenna amplifier is working
properly, the TV picture will now be degraded
(snowy). When you turn the switch back on, the
picture should again be sharp.
PHONE AND CABLE TV-
HOOK-UPS
Some models are equipped with ex-
ternal connections for telephone and
cable television. The connectors are
located in the shoreline cord com-
partment.
VIDEO SELECTOR SYSTEM
The video selector system allows you to
switch the antenna, cable TV or VCR signal to
any TV set location in the coach.
Summary of Contents for 2003 adventurer
