8-9
SECTION 8
APPLIANCES & INTERIOR FEATURES
2. Move thermostat switch from OFF to HEAT
and press the Temp Selector button (Up/
Down arrows) until the desired temperature
is shown on the display.
3. Furnace fan will start to blow immediately
after setting thermostat.
4. After about 30 seconds, the furnace burner
will light.
5. The furnace will now cycle off and on auto-
matically as the thermostat demands just like
a household furnace.
NOTE: If heat does not come out of the heat
ducts after a minute or so the burner is
not lit. Turn thermostat off for 3-5
minutes, check to be sure tank valve is
open and tank is not out of fuel, then try
steps 2-4 again. If it still will not light
after three attempts, go to Shut Down
steps and contact your dealer or a local
RV service center.
NOTE: Metal coatings used during manufacture
of the furnace burner may smoke when
the furnace is used for the first time,
which may also set off your smoke alarm.
If this happens, provide adequate venti-
lation of the smoke to avoid a nuisance
smoke alarm at this time. We do not rec-
ommend removing the smoke alarm bat-
tery. If it were inadvertently left
disconnected, the smoke alarm would be
inoperative.
To Shut Down:
1. Slide thermostat switch to OFF position.
2. Close LP tank valve.
For Further Information
Please see the Suburban furnace operating
instructions provided in your Owner InfoCase
for further information, including operating pre-
cautions, and periodic maintenance.
