SECTION 12 –
MISCELLANEOUS
12-12
NOTE: As a safety feature, the awning will not
extend if the ignition key is on.
Wind Sensor Auto-Retract Feature
The Auto-Retract System is active when the
awning power is on and disabled when the power
is shut off. Press the power button On to to
activate the system.
During windy conditions, the Direct Response
System detects awning motion. (The motion
sensor is located in the awning rail.) The system
operates by gauging the vertical motion of the
awning’s leading edge. When continuous motion
exceeds the factory preset threshold for two
seconds or longer, the awning will retract
automatically. The control panel provides four
factory preset threshold values. You may want to
experiment to find the best setting that suits your
needs.
•
LOW - The lower the selection of threshold,
less motion is required before the system
closes automatically.
•
HIGH - The higher the selection of threshold,
more motion is required before the system
closes automatically.
Wind gust detection is incorporated into the
awning software. When the motion value is
suddenly and sharply increased above a safe
maximum value, then the two second persistence
measure is overridden and the awning will
immediately close.
Further Information
For complete operating instructions, refer to
the manufacturer’s information provided in your
InfoCase.
AIR HOSE CONNECTOR
–Freightliner Chassis
For convenience, your coach is equipped with
a quick-connect air coupler to which you can
connect an air hose for inflating tires or sports
and camping equipment if needed.
NOTE: Air hose and inflation or blowing
attachments are not supplied and must be
obtained separately.
The quick-connect coupler is located behind
the hood panel at the front end of the vehicle.
Instructions for connection and disconnection are
shown on the label at the coupler.
Awning Remote