3-7
SECTION 3 –
DRIVING YOUR MOTOR HOME
A microphone built into the rear camera lets
you hear warning sounds or verbal directions
from an assistant.
Basic Operating Instructions
*Sideview Cameras
– If Equipped.
The optional sideview cameras allow you to
see what’s beside you before turning or changing
lanes.
The sideview cameras activate with the
corresponding turn signals and replace the rear
camera view on the monitor until the turn is
completed or the signal lever is canceled
manually.
Further Information
See the rearview monitor manufacturer’s
complete operating information in your
InfoCase.
ELECTRONIC COMPASS AND
OUTSIDE THERMOMETER
Further Information
See the compass manufacturer’s guide in your
InfoCase for detailed operating instructions,
calibration, specifications and other information.
POWER SUNVISORS
–If Equipped
The powered sunvisors are controlled by
switches on the driver and passenger armrest
panels.
•
Press and hold the desired switch DOWN to
extend or UP to retract, then release at the
desired position.
•
Driver side switches allow the driver full
control of all visors.
•
Passenger side switch controls only the
passenger side visor.
NOTE: Do not position visors where they will
impair the driver’s forward vision or side
mirror views.
Power
- Turn ON to activate
monitor for rear viewing while
driving or parked. Key must be on.
In OFF (Standby) position the
monitor is ‘asleep’ and will ‘wake
up’ when the transmission is
shifted into Reverse.
Camera -
CA1= Rear or Side* cameras
CA2= not used
Day/Night -
Press to adjust
contrast and brightness for
nighttime and daytime lighting
conditions. After making
adjustments, button is used to
switch between settings.
Volume, contrast and brightness
are self-explanatory.
•
F/C Button -
Press to switch between
Fahrenheit and Celsius temperature degree
scales.
When display is off, press and hold to check
temperature.
•
Mode Button -
Press to ‘page through’
functions: Compass > Thermometer >
Calibration