7-3
SECTION 7 –
PLUMBING
To Clean Pump Strainer
•
Be sure all water pump switches are OFF.
•
Twist the inlet cap (bowl) counterclockwise to
unscrew from the strainer assembly.
•
Remove the bowl and pull the strainer screen
out of the bowl to tap out any particles and
rinse clean.
•
Insert the strainer screen back into the bowl,
then screw the bowl back onto the strainer
assembly.
NOTE: You must also empty the strainer when
winterizing your coach to avoid water
freezing and cracking the filter bowl.
Water Pump Switch
The water pump switch is located on the
systems monitor panel. (Some models may have
an additional switch in the water service center.)
While the switch is “ON”, the pump will
automatically supply water as it is needed.
We recommend that you turn the water pump
switch off whenever you will be away from the
vehicle or not using the water system. In time, a
slow leak in a faucet could drain the water tank,
fill the holding tank and discharge the house
batteries.
Initial Water Line Priming
1. Make sure that all water drain valves are
closed, including water heater valve.
2. Turn water pump switch to “OFF” position.
3. Fill water tank.
4. Open all faucets, hot and cold.
5. Turn on pump switch.
6. Close each faucet as it begins to deliver a
steady stream of water (close cold water first).
Leave hot water faucets on until they also
deliver a steady stream of water. This will
ensure that the water heater is filled with
water.
7. Check to be sure pump stops soon after all
faucets have been closed.
8. Pump is now ready for automatic operation.
Pump will start when a faucet is opened and
stop when the faucet is closed.
Unscrew bowl and remove to clean strainer
Water Pump Strainer
in Water Service Center (typical)
Water Pump Switch
on OnePlace Panel
Water Pump Switch
in Water Service Center