7-17
SECTION 7 –
PLUMBING
3. Let the ice maker run through a cycle, then
raise the shut-off arm.
4. Be sure water has drained from ice maker
supply line, then reconnect to inlet valve.
5. Done - Ice Maker is now winterized.
Go to next optional appliance or go back to
Blow Out Procedure Step 9- Drain Water
Heater or Antifreeze Fill Procedure Step 14.
To use Ice Maker again:
Flush antifreeze from the water lines, then
1. Close all drain valves.
2. Turn the water supply on.
3. Be sure the ice bin is in place and the
automatic shutoff arm is down.
4. Let the refrigerator cool down to ice making
temperature. Remember, this can take up to 24
hours.
5. Let the ice maker cycle and dump the first
batch of ice.
Done.
Winterizing Washer-Dryer
–If Equipped
Method 1– Drain Water
If you’ve decided to completely drain the
water lines, follow these steps to winterize your
washer-dryer:
1. With the machine power OFF, pour 1/2 quart
of RV-type antifreeze into the washer drum
2. Close the door. Advance the Program Selector
knob to a SPIN position
3. Press ON/OFF Button (IN). Wait 1-2 minutes
4. Press ON/OFF Button (OUT). Unplug the
washer-dryer from the electrical outlet (or
disconnect power)
5. Turn the water supply faucets OFF.
Disconnect the inlet hoses from the faucets.
Drain any remaining water from the hoses.
6. Done - Washer/Dryer is now winterized.
Go to next optional appliance or go back to
Blow Out Procedure Step 9- Drain Water
Heater or Antifreeze Fill Procedure Step 14.
Method 2– Fill with RV Antifreeze
If you’ve decided to fill the water lines with
RV antifreeze, follow these steps to winterize
your washer-dryer:
1. With the machine power OFF, turn the WASH
TEMP knob to HOT.
2. Advance the Program Selector knob to
REGULAR in Cotton Heavy Duty.
3. Press the ON/OFF button (IN) and let the
machine fill until antifreeze is in the drum.
4. Advance Program Selector to a RESET. Wait
5 seconds (Status/Door Lock LED will blink).
5. Advance Program Selector to a SPIN
position. Let the antifreeze drain from the
drum.
6. Advance Program Selector to RESET. Wait 5
seconds (Status/Door Lock LED will blink).
7. Turn the WASH TEMP knob to COLD.
8. Advance the Program Selector knob to
REGULAR in Cotton Heavy Duty.
9. Let the machine fill until you see antifreeze in
the drum.
10. Advance the Program Selector knob to
RESET. Wait 5 seconds (Status/Door Lock
LED will blink).
11. Advance the Program Selector knob to SPIN.
Let the antifreeze drain from the drum.
12. Press the ON/OFF button (OUT).
13. Done - Washer/Dryer is now winterized.
Go to next optional appliance or go back to
Blow Out Procedure Step 9- Drain Water
Heater or Antifreeze Fill Procedure Step 14.
Ice Maker Water Supply Connection