8-7
SECTION 8 –
ENTERTAINMENT
NOTE: The buffet TV is plugged into a special
electrical outlet with a built-in ignition
switch interlock. This device allows the
TV to operate only when the ignition key
is in the Off or Accessory position. The
TV will not be operational when the
chassis engine is running.
1. To raise the TV, press the control switch UP
and the TV will pop up through the access lid.
2. Continue to raise TV to the height that best
suits your viewing needs.
3. To lower the TV back into stored position,
press the control switch DOWN. The power
lift/lower mechanism will stop automatically
when the TV is all the way seated into stored
position.
NOTE: Be sure that the buffet counter is clear
before raising/lowering the TV to protect
the TV, lift/lower mechanism, and
personal property from possible damage.
TV ANTENNA
The TV antenna on your motor home can be
easily raised, rotated a full 360
°
and lowered
from inside the vehicle by simply turning a crank
or directional handle. A built-in signal amplifier
designed to strengthen signals, is controlled by a
power switch built into the optional video
selector panel or on a wall plate assembly.
See the antenna manufacturer’s operation,
care and maintenance information in your
InfoCase.
Raising Antenna to Operating Position
Turn elevating crank clockwise in “UP”
direction until some resistance to turning is noted
(about 13 turns). Antenna is now in operating
position.
Turn amplifier power switch “ON” to receive TV
signal.
WARNING
Never allow the antenna to touch
electrical power lines or any other
electrical wires.