SECTION 4 -
APPLIANCES AND SYSTEMS
4-10
WASHER/DRYER – PREP
PACKAGE
If your motorhome is not equipped with a
Washer/Dryer, plumbing may be present for
installation.
Typically, the plumbing lines are located
inside the wardrobe or storage cabinet depending
on model.
We recommend obtaining parts and service
for the Washer/Dryer installation from your
Winnebago Industries
®
dealer.
SYSTEMS MONITOR PANEL
The Systems Monitor Panel provides a
convenient central location for checking the
condition of all utility systems in your
motorhome.
At the touch of a button, this panel will display
the fresh water and holding tank levels, propane
gas tank level, plus the house battery condition.
You can start the generator or turn on the water
pump and water heater. Indicator lights tell you if
the water pump is on or if the water heater pilot
light is out.
Water And Holding Tank Levels
Press and Hold the “Levels Test” switch to
show approximate level on the monitor lights.
The approximate fluid levels are measured by
electronic sensors on the sides of the tanks. There
is generally more fluid in a tank than indicated on
the monitor panel.
For example, if the fluid level is 1-2” below
the FULL sensor, the monitor will show the level
to be only 2/3 even though the tank is nearly full.
If a tank is about 1/4 full, the monitor will
register an empty tank because the fluid level is
below the 1/3 sensor even though there is still
fluid in the tank.
However, when the indicator reads FULL, the
tank is actually full.
Black and Gray Waste Level
Selector Switches
(Models 35F only)
This model has two black water tanks - one in
the front, and the other in the rear. Because the
monitor panel can display only one black water
tank level at a time, a selector switch is provided.
Water Tank
Water Level
Sensors
