10-5
SECTION 10 –
SLIDEOUT ROOMS
There are two slideout motors equipped on the
end wall of each slideout room. Pull back wipe
seal to access motors.
Push-In Procedure
1. Pull back wipe seal to access slideout motor.
2. Using a flat-head screwdriver, push bottom of
slideout motor UP to disengage
(approximately 1/2” from base).
Repeat on opposite slideout motor.
3. Push slideout room in to travel position,
ensuring both sides are relatively even.
NOTE: Several people may be needed to push
the room in.
4. When the slideout room is fully retracted,
secure the room with a support item (e.g. 2x4
wood board) above the interior slideout room
to secure room during travel.
NOTE: For larger slideout rooms, place a travel
support item on each end of the interior
slideout room.
Slideout Motor
(Located behind slideout wipe seal)
• Use a screwdriver to push slideout motor
UP (disengage).
• Ensure slideout motor is disengaged
approximately 1/2” from base.
Slideout Travel Support
• Place support item (e.g. 2x4 wood
board) above interior slideout room as
shown.
