SECTION 7 –
PLUMBING
7-6
Replacing the Cold Water Filter
Cartridge
You should replace the filter cartridge every
season and when water flow from the faucet is
too slow for convenience. The cartridge must be
replaced at least every 12 months.
Further Information
See the water filter manufacturer’s operation
information in your InfoCase for filter cartridge
replacement.
COLD WATER FILTER
–If Equipped
To obtain filtered cold water for drinking or
cooking, simply open the galley sink cold water
faucet.
NOTE: Only the galley cold water faucet is
filtered.
The cold waterline flows through an activated
carbon filter that removes chlorine and odors for
taste-free drinking water.
Replacing the Cold Water Filter
Cartridge
You should replace the filter cartridge every
season and when water flow from the faucet is
too slow for convenience. The cartridge must be
replaced at least every 12 months.
•
Place a container beneath the filter to catch
any water remaining in the waterlines during
filter removal.
•
Twist the filter cartridge “counter-clockwise”
about one-quarter turn, then pull it down and
out of the filter socket.
•
Insert a new water filter cartridge up into the
filter socket as far as possible and twist it
“clockwise” one-quarter turn until it stops.
•
Before using the water for drinking, run a few
gallons of water through the filter and discard
water to avoid consuming carbon dust or
particles that may have been present in the
new filter cartridge.
Diverter Plug
•
Install the diverter plug into the filter socket
for winterization or if water must be used
while the filter is removed from the socket.
The diverter plug is installed in the same
manner as the water filter.
Cold Water Filter Assembly
(Located below galley sink)
NOTE: Hot waterline is not filtered.
• Insert new filter up into filter socket -
press and twist 1/4 turn “clockwise”.
Diverter Plug (installed in filter socket)
• Insert and twist 1/4 turn “clockwise”.
