8-1
5 - DASH / AUT
O
SECTION 8 – ENTERTAINMENT
HDMI VIDEO SELECTION
SYSTEM
The HDMI Video Selection System allows
you to watch high definition video from multiple
sources on multiple TV’s at the same time. You
can select either
Blu-ray, Satellite Receiver 1,
Satellite Receiver 2, or Auxiliary (Dash Radio
House Mode)
.
TVs connected to this system are the Lounge
TV, 2nd Lounge TV (if equipped), Bedroom TV,
and Exterior Entertainment Center TV.
All TV’s and A/V sources operate from 120-
volt AC household current only, so you must
have either the shoreline connected, the generator
running, or the inverter turned on (if equipped).
NOTE: Red lights that are illuminated on the
HDMI Video Selection System and the
Secondary Source Selector indicate that
video sources are active.
Blue lights that are illuminated indicate
the selected video source.
NOTE: There will be a slight delay when
changing sources. Winnebago
Industries
®
recommends setting each
component to a maximum video output
resolution of 1080i for proper operation.
Select Video Source and TV
•
Power “ON” TV, HDMI Video Selection
System, TV, Sound Bar (if desired), and Video
source (DVD player, Satellite receiver(s), or
Dash radio).
•
Press and release button for desired TV
viewing (e.g. BEDROOM for bedroom TV)
until the number is lit for the desired source
(e.g. Blu-Ray).
•
At the TV, ensure the source (or input) is set to
HDMI.
Secondary Source Selector
A Secondary Source Selector is provided at
each TV for your convenience. Press the Select
button to toggle to preferred source.
Infrared Emitters
The HDMI Video Selection System in your
coach is also featured with Infrared Emitters
(connected to both Accessory Connection
Cables), which are used to extend the remote
control from all TV’s in the coach to either
Satellite 1 or Satellite 2. Install Infrared Emitter
by removing the protective cover from adhesive
and place directly in front of the I.E. Receiver on
the component.
HDMI Video Selection System
(Located in front passenger overhead cabinet)
HDMI Video Selector
Control
(Located in your InfoCase
Box)
• Used to control main
HDMI Video
Selection System only.
HDMI Video
Selection
System
Secondary Source Selector
(Located near each TV)
Secondary Source
Selector Control
(Located in your
InfoCase Box)