3-9
SECTION 3 –
DRIVING YOUR MOTORHOME
VALVE STEM ACCESS
(Mercedes-Benz
®
Sprinter Chassis)
Front Wheel Valve Stem Access on
18-Hole Steel Wheel with Push-On
Full Wheel Trim
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” cap tool (provided in your
InfoCase).
3. Push the end of the cap tool onto the front
wheel valve stem cap.
4. Using the cap tool as a remote handle,
unscrew the valve stem cap (retaining cap in
the end of the tool).
5. Adequate clearance is available to insert the
tire gauge onto valve stem.
6. When tire pressure testing is complete,
reinstall the valve stem cap (with the cap still
retained in the cap tool end).
7. Remove cap tool from valve stem cap.
Rear Inner Dual Valve Stem Access
on 18-Hole Steel Wheel with Push-
On Full Wheel Trim or Stylized
Chrome Wheels
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” cap tool (provided in your
InfoCase).
3. Push the end of the cap tool onto the rear inner
dual valve stem cap.
