11-9
SECTION 11 -
MAINTENANCE AND STORAGE
8. Sanitize the water system as outlined under
“Disinfecting the Fresh Water System” in
Section 7 - Plumbing
, then flush the
waterlines thoroughly with fresh water.
9. Check the toilet for proper operation.
10. Add water to the holding tank using the toilet
flush lever and galley sink faucet. Ensure
dump valves seal tightly.
11. Check around all appliances for obstructions
and ensure that all vent openings are clear.
12. Start refrigerator and check for proper
cooling.
13. Clean wall and counter surfaces.
14. Replace batteries, if necessary, and check out
electrical system to make sure all lights and
electrical components operate.
15. Check tires for proper cold inflation pressure.
See “Vehicle Certification Label” in
Section 1
- Introduction.
16. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents, and any other joints.
See
Sealants – Inspection and General
Information
at the beginning of this section.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate
compounds are available from your dealer.
See “Sealants – Recommended Application”
page in the Supplement Manual provided in
your InfoCase.
Also inspect weather seals around doors, etc.,
and if necessary, have a dealer replace
immediately.
CHASSIS SERVICE AND
MAINTENANCE
Consult the appropriate sections in the chassis
manual for specific information regarding
operating safety, service recommendations, and
maintenance schedules for the chassis section of
your vehicle.
