10-11
SECTION 10 –
SLIDEOUT ROOMS AND LEVELING
2. Using a flat-head screwdriver, push it up
underneath the screw cover and pull up to
release the cover. Remove the rest of the cover
by hand and set aside.
3. Remove the top (4) pan head screws and top
(4) flat head screws at the top of the aluminum
trim.
4. Gently pull aluminum trim away from
sidewall with hand to disengage screw from
motor.
5. Using a flat-head screwdriver, push bottom of
slideout motor UP to disengage
(approximately 1/2” from base).
Repeat on opposite slideout motor.
Slideout Motor
(Located behind slideout wipe seal)
• Use a screwdriver to push slideout motor
UP (disengage).