10-3
SECTION 10
STORING YOUR MOTOR HOME
19. Close all windows and roof vents. Protect all
appliance vent openings from contamination
by animals or insects (e.g. bird nests, wasp
nests, etc.)
20. Lubricate all door hinges and locks.
21. Clean the interior of the coach. Dirt and
stains are more easily removed when fresh.
22. Remove all foods and items that may cause
odors.
23. Clean and defrost the refrigerator. Leave the
door slightly ajar to allow any odors to dissi-
pate. Place an open box of baking soda
inside the refrigerator to help absorb odors.
24. Turn the furnace thermostat switch on the
bottom of the thermostat to OFF.
25. Disconnect all chassis and auxiliary battery
cables.
26. Fully charge all batteries. Batteries must
have at least 80% charge to survive freez-
ing temperatures and long periods of non-
use.
NOTE: We do not recommend leaving the shore-
line plugged in continuously during stor-
age periods because the batteries can
lose electrolytic fluids and become dam-
aged from continuous charging without
periodic use. We recommend following
regular battery inspection and mainte-
nance, especially in cold weather. See
“Battery Maintenance” on page 6-7.
REMOVAL FROM
STORAGE
1. Completely air out the motor home.
2. Have the entire LP gas system checked for
leaks.
3. Check window operation.
4. Check cabinet and door hinges. Lubricate
with penetrating oil, if necessary.
5. Close all faucets and drain valves that are
open. If necessary, reconnect toilet water line
and close flush valve.
6. Add a few gallons of water to the fresh water
tank and check for leaks especially at junc-
tions. Also make sure all hangers and sup-
ports are securely in place. Sanitize the water
system as outlined under “Disinfecting the
Fresh Water System” in Section 7.
7. Check operation of all faucets to be sure fau-
cet washers have not hardened during stor-
age.
8. Check sealing valve in the toilet for proper
operation and lubricate with silicone spray.
9. Add water to the holding tank using the toilet
flush pedal. Check to be sure dump valve
seals tightly.
10. Check around all appliances for obstructions
and ensure that all vent openings are clear.
11. Start refrigerator and check for proper cool-
ing.
12. Clean paneling and counter surfaces and
apply a thin coat of wax.
13. Replace batteries if necessary and check out
electrical system to make sure all lights and
electrical components operate.
14. Check tires for proper cold inflation pres-
sure.
15. After washing accumulated winter grime
from the vehicle, it is important to carefully
inspect the seams and sealants for separation
or cracks that may have appeared around the
window frames, vents and any other joints.
Re-sealing is quite simple and the material is
quickly and easily applied. Appropriate com-
pounds are available from your dealer. Also
inspect weather seals around doors, etc., and
if necessary, have a dealer replace immedi-
ately.
