ASSEMBLY INSTRUCTIONS
WINNERS ONLY
R
PROD. NO : DH44096N-T&B
Thank you for purchasing this quality product. Be sure to check all packing material carefully for small parts that may have come loose inside the carton
during shipment.
Components List :
DESCRIPTION
NO
SIZE
Flat Washer
1
5
16
" x 22 mm
SKETCH
QTY
Spring Washer
2
5
16
"
Hexagon Nut
3
5
16
" x 7 mm
Spanner
4
12.8 mm
16pcs
16pcs
8pcs
1pc
Reminders
1. Use only the hardware supplied.
2. Once the chair is finished, level and tighten all the bolts.
3. Do not over tighten bolts.
4. This item may require periodic tightening.
NOTE :
1. Hardware pack is located underneath the Table Top (A).
2. Two or more people are needed for assembly. Please keep all hardware
part out the reach of children.
1 OF 3
MADE IN MALAYSIA
NO
SKETCH
QTY
Table Top
A
1pc
DESCRIPTION
Center
Leaf
B
2pcs
Pedestal
C
4pcs
NO
SKETCH
QTY
Base Leg
E
2pcs
F
G
2pcs
Hardware List :
JCBC Bolt
5
M8 X 80mm
6pcs
6
Please keep all hardware parts out of the reach of children.
1. We recommend that you should assemble this product with the assistance of another person; this will make the assembly easier, and will help to prevent personal injury and to insure parts
are not damaged during the assembly process.
2. Before beginning, please check the packing materials carefully for small parts which may have come loose inside the carton during shipping. Please do not discard any packing material
until all parts have been located. If any parts are missing, please contact your dealer for prompt replacement.
3. To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain residues and rough surfaces and also check for staples or nails left after removing the
packing materials. The manufacturer will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday, screws, bolts, nuts and wooden plugs may loosen up. They should be periodically inspected and re-tightened to
prevent damage to the furniture and (or) personal property or cause injury. Always check to be sure all hardware on this list and the below mentioned components are attached to the
furniture properly and kept tightened.
5. Please lay all parts and hardware on a non abrasive surface such as a carpet, and follow the assembly steps.
TIP: Store the Allen key and (or)Wrench used in assembly in this product's drawer or use masking or painter's tape to
affix it to the underside of the product.This will make it easier to find if you want to periodically tighten bolts or
disassemble the product.
DESCRIPTION
Pedestal
Side
1pc
1pc
Allen Key
M5
D
2pcs
Center
Structure
Mounting
Plate
Flat Washer
7
1
4
" x 18 mm
Spring Washer
8
1
4
"
8pcs
8pcs
9
JCBC Bolt
M8 X 60mm
2pcs
10
JCBC Bolt
M6 X 50mm
8pcs
11
1pc
Allen Key
M4
