WINNERS ONLY
®
ASSEMBLY INSTRUCTIONS
PROD. NO: DST54041
Thank you for purchasing this quality product. Please read instructions thoroughly before unpacking
the assembly parts.
1 OF 2
Caution : Sharp exposed staple tips can cause injury, therefore for your protection, please remove any exposed
staples used in packing.
Please keep all hardware parts out of the reach of children.
1. We recommend that you should assemble this product with assistance of another person; this will
make the assembly easier, and will help to prevent personal injury and to insure parts are not damaged during
the assembly process.
2. Before beginning, please check the packing materials carefully for small parts which may have come
loose inside the carton during shipping. Please do not discard any packing material until all parts have been
located. If any parts are missing, please contact your dealer for prompt replacement.
3. To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residues and rough surfaces and also check for staples or nails left after removing the packing materials.
The manufacturer will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday, screws, bolts, nuts and wooden
plugs may loosen up. They should be periodically inspected and re-tightened to prevent damage to the furniture
and (or) peronal property or cause injury. Always check to be sure all hardware on this list and the below
mentioned components are attached to the furniture properly and kept tightened.
5. Please lay all parts and hardware on a non abrasive surface such as a carpet, and follow the assembly.
Hardware List:
2
QTY
SKETCH
DESCRIPTION
NO
1
SIZE
This product will take 15-20
minutes to assemble
3
Screw driver is require for assembly (not included)
TIP:
store the Allen key and or Wrench used in assembly in
this product's drawer or use masking or painter's tape to
affix it to the underside of the product. This will make it
easier to find if you want to periodically tighten bolts or
disassemble the product.
Components List:
B
QTY
SKETCH
DESCRIPTION
NO
A
TABLE TOP
4 PCS
LEG
1 PC
4
MADE IN MALAYSIA
5
16
"
X
65mm
8 PCS
SPRING WASHER
M8
X
13mm
8
PCS
8 PCS
FLAT WASHER
M8
X
18mm
HEX BOLT
1 PC
WRENCH
12.8mm
