OLS-16032-SNN
Reminders :
Two people are needed for assembly.
Use only hardware supplied.
Do not over tighten bolts.
This item may require periodic tightening.
MADE IN MALAYSIA
Page 2 of 2
HARDWARE PART :
Flat Washer
Allen Key
Lock Washer
1 pce
JCBC Bolt
JCBC Bolt
(Short)
(Long)
8 pcs
4 pcs
12 pcs
12 pcs
ASSEMBLY :
STEP 1
Turn the Table Top upside down on a protective surface such as carpet or other soft material.Place the three legs to the corner of the
apron then insert the
Flat Washer
,
Lock Washer
and
JCBC Bolt(Long)
into pre-drilled holes on the corner block and tighten it by using
the
Allen key
provided.
Insert the Fixed Shelf into the assembly legs as shown in the diagram, then install the fourth leg by use
Flat Washer
,
Lock Washer
and
JCBC Bolt(Long)
into pre-drilled holes on the corner block and tighten it by using the
Allen key
provided. Continue by using the
Flat Washer
,
Lock Washer
and
JCBC Bolt(Short)
into pre-drilled holes on the corner block of
Fixed Shelf and by using the
Allen key
provided.
STEP 2
Check its balance and tighten all bolts to complete the assembly.
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
IMPORTANT NOTE :
~ Please keep all hardware out of the reach of
children.
T2-NP101E--0
LAMP TABLE
Allen Key
Allen Key
JCBC Bolt
(Short)
JCBC Bolt
(Long)
Lock Washer
Lock Washer
Flat Washer
Flat Washer
PARTS LIST
OSS-16031-TDG
MADE IN MALAYSIA
Page 1 of 2
T2-VT100S--G,T2-SF100S--C
SOFA TABLE WITH 2 DRAWERS
PART NO
FIGURE
DESCRIPTION
QTY
Legs
Table Top
1 pce
4 pcs
1 pce
T2-VT100S-01,
T2-SF100S-01
T2-VT100S-13,
T2-SF100S-13
T2-VT100S-13,
T2-SF100S-13
T2-VT100S-22,
T2-SF100S-22
T2-VT100S-22,
T2-SF100S-22
T2-VT100S-07,
T2-SF100S-07
T2-VT100S-07,
T2-SF100S-07
Hardware Bag
1 pce
Fixed Shelf
IMPORTANT NOTE :
Please keep all hardware parts out of the reach of children.
