WiNRADiO G315 User’s Manual
51
Scanner Configuration
When a signal strength level is higher than the squelch level, this indicates that
a signal has been found. You can configure the software to specify what action
you want to be taken at this point. To access this configuration facility, go to
Options | Scanning
in the top bar menu.
There are two basic actions the software can do when a signal is found:
Pause
scanning or
Stop
scanning. If
Pause
is selected, then you need to
further specify the conditions under which the scanning will
Resume
. The
conditions to resume can be one of the following:
•
When the signal disappears
(i.e. the scanning resumes immediately when
the signal disappears)
;
•
After ‘Delay time’
(i.e. no matter if the signal disappears during the user-
defined Delay Time interval or not, the software will always wait for the
entire Delay Time interval, and only then resume scanning
);
•
When a signal disappears during ‘Delay time’
(i.e. the scanning will not
resume if the signal returns within an interval shorter than, or equal to,
Delay Time);
•
When no signal during ‘Delay time’
(i.e. the scanning will resume if there is
a no-signal gap equal to, or longer than, Delay time).
The
Delay time
interval can be set from 1 to 100 seconds.
