WiNRADiO G315 User’s Manual
53
Frequency Range Scanning
To be able to use Frequency Range Scanning, you need to set up the desired
scanning ranges first. This is done using the
Ranges
button in the
Options |
Scanning
top-bar menu.
Note the check box at the start of a range. This is useful in situations where
you may have several ranges defined, and you wish to enable only one or
several from the list, without the need to redefine the whole range list each
time you want to make change in one range only. Use the checkbox to select
the particular range(s) you wish to include in range scanning.
A very useful feature of frequency range scanning is that all found frequencies
can be automatically stored in memory, even if the receiver is left unattended.
To do this, enable
Auto Store
and specify the memory number range to which
the frequencies should be written. You can also specify a special Group
Number to be assigned to such frequencies.
When using the Auto Store option, you should also set the appropriate
conditions in
Scan Settings
to take effect when the signal is found. For
example,
Pause when signal appears
, and
Resume
after the minimum delay
time will provide the fastest scanning and writing into memory).
Note that if
more signals are found than there are allocated memories, the excess
frequencies will not be stored.
