CODE LEARNING
Step 1 :
Installing the Control Module
Connect all the wire harnesses, and power the module as per the installation
guide. Make sure to close the door, the trunk and the hood of the vehicle.
Do not start the engine. You have 30 seconds to complete Step 2.
Step 2 :
Setting Code Learning Mode for the LCD receiver
a)
Press and hold Button (
) more than 1 second or until you hear a short beep
tone.
b)
Press Button (
) 4 times. The current time will change to (0:00), indicating
the LCD receiver is on code learning mode and is communicating with the
main control module.
Step 3 :
Receiving ID Data.
When ID data is successfully delivered to the LCD receiver, (0:00) changes to
current time and LCD screen will be back to Standby Mode by emitting a song
titled as Congratulation.
The Out-of –Range icon will re-appear at the left top corner of the screen to
confirm that the operation is terminated.
Step 4 :
Testing Car Monitor.
Arm the host alarm and Open / Close the door, the hood, the trunk or start the
vehicle.
Tempered location must be displayed on LCD screen as it occurs.
Otherwise re-do steps 1 to 4.
6 - 9
BLOCK DIAGRAM FOR CODE LEARNING
Install Car Monitor TX
