EPX-C414/Configuration
v1.0
www.winsystems.com
Page 45
7.11.2 JPMSATA
Select either MiniPCIe or mSATA at socket MC2.
Layout and Pin Reference
7.11.3 JPLCDP Panel Power Jumper
Layout and Pin Reference
Additional Information
The EPX-C414 has an integrated display controller that interfaces to both Analog VGA
and flat panel displays. The video output mode is selected in the CMOS setup.
Simultaneous flat panel and Analog VGA mode is also supported. The Analog VGA
connector is located at VGA. WinSystems offers the cable CBL-VGA-002-12 to simplify
the connection. The LVDS interface connector is located at
J7
to interface to flat panels.
A backlight power connectors is located at BKLT. The panel power option selection is
made at JPLCDP.
Contact a WinSystems Applications Engineer for information about available cable kits
and supported panels.
This manual does not attempt to provide any information about how to connect to
specific LCDs.
Selection
Jumper Positions
PCIe (L)
Jumper pins 1 and 2 together
mSATA (H)
Jumper pins 2 and 3 together
□ □
1 2 3
Panel Power
Jumper Positions
5V
Jumper pins 1 and 2 together (VGA)
3.3V (Default)
Jumper pins 2 and 3 together
(DP or LVDS)
□ □
1 2 3
Avoid simultaneous jumpering of pins 1-2 and 2-3. Mis-jumpering panel power
causes damage to the board or the flat panel
