Dis abled
C8000
CC000
D0000
D4000
D8000
DC000
E0000
Note : This mode of us age is mu tu ally ex clu sive of any on board sili con disk us age. Fur ther note that
'Di sabled' must be se lected when any SSD mode is de sired.
3.6
Chipset Fea tures Setup
The op tions in this sec tion con trol the chipset pro gram ming at boot time. In most cases, the de fault
set tings should be used un less you have a clear un der stand ing of the sig nifi cance of the change. It is pos -
si ble us ing these op tions to cre ate a sys tem that will ei ther not boot or is very un sta ble or un re li able. If
this should oc cur, there are two meth ods to re turn the sys tem to a sta ble con figu ra tion. If the sys tem
works well enough to get into Setup, sim ply choose the “Load BIOS De faults” op tion and then se lect
“Save and Exit Setup” to re store fac tory de faults. If the sys tem will not run well enough to run Setup, it
will be nec es sary to re move the bat tery source tem po rar ily un til the CMOS mem ory de cays. Ref er to
Sec tion 2.X for de tails on re ini tial iz ing the CMOS RAM.
Each of the op tions for the Chipset Fea tures Menu will be briefly dis cussed in the sections that fol -
low.
Auto Con figu ra tion
This op tion, when en abled, in structs the BIOS to auto- select the proper AT Bus Clock, the DRAM
read tim ing, the DRAM write tim ing, the SRAM read tim ing, and the SRAM write tim ing base upon the
cal cu lated CPU speed. The de fault is “En abled”.
Page 3 - 10
OPERATIONS MANUAL LBC-Plus
991206
WinSystems - "The Embedded Systems Authority"
