1
2
3
17
CONNECTIONS
S-Video or component video output
This is a higher quality connection than standard composite video, and requires a special S-Video cable not included.
The S-Video connector is distinguishable by its 4 pins, as shown below. If your TV has an S-Video input, it's
recommended that you use this type of connection for better picture quality.
Turn on the unit and select the DVD mode.
Component Video
The highest quality video connection, component video requires separate cables for the Y, Pb/Cb, Pr/Cr signals. To
use the progressive scan option on this unit, you'll need to use the component video output. Using the component
video output requires these steps:
1
2
First, use the supplied A/V cable to connect to the
component video input on your TV. Select this input.
Changing the TV OUT MODE to the progressive scan by
press the PSCAN and SELECT key. Select the correct
video input on your TV.
Component Video
Input Jacks
Y
Pb/Cb
Pr/Cr
Component
Video Cable
Resetting the video output
If you inadvertently switch the OUTPUT FORMAT setting to
PROGRESSIVE while using a standard TV not capable of
PSCAN, you will lose video. If this happens, reset the
recorder to its default video settings by pressing PSCAN
and SELECT on the remote.
Y
Pb
Pr
S
L
R
S-Video
Input Jack
S-Video Cable
TV with
Component
Video Input /
Progressive Scan
cap ability.
VIDEO
INPUT
TV with
S-Video Input
VIDEO
INPUT
First, a special S-Video cable. Connecting the S-
Video output from the unit to the corresponding input
on your TV.
On your TV, select the s-video input. This is
noumally done by selecting Ycb/cr or Ypb/pr or
S-VIDEO With the remote control. On some TV S
this is done by selecting a particular channe.
