19
End Time:
Enter the end time by using the numeric key on the RCU.
Channel No.:
Select the desired channel No.
After setting well, press
OK
to finish.
The task can be set to inactive or active by using
keys in the schedule.
5. Accessory
5.1 System Information
In this menu, you can view the system version.
5.2 Factory Default
Select the Factory Default item in the
Accessory menu and press the
OK
key. A
sub-menu will seek your confirmation. Select
YES key to restore factory defaults.
Note :
Reset to Defaults should be used with
care as all programs found will be erased and
Parameters re-set to factory default using this
function.
5.3 System update
* Used for Servicing purposes only
The STB can upgrade new system version by
using RS232.
1. Power off the master and slave STB.
2. Connect master STB to slave STB by a
crossed 'RS232 serial cable'. (Data will transfer
from master STB to slave STB)
3. Power on the master receivers.
4.
Enter the System update window,
Summary of Contents for STB1SD
Page 9: ...9 6 Remote Control Unit...
